• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

overdrive/fuzz quest part 2

a couple more that were previously built, tested, and finally mounted in their enclosures. both of these sound great! ;)

Zvex Box of Rock:

BOR-01.jpg


BOR-02.jpg



TS808 (modded for bass):

TS808-01.jpg


TS808-02.jpg
 
As an eBay Associate, TalkBass may earn a commission from qualifying purchases.
Hey John,

Any chance you could whip up a 'Invalid Link Removed'?

They're discontinued, and I can only find a schematic for the non-bass version. Or maybe just give me some advice about modding the non-bass version for bass? I'm still a noob at this, but really want to build one.

Thanks again for such an awesome thread!
 
the other one was a diversion from buuilding dirt pedals. I already own a Boss OC-3 but I wanted an OC-2 only with a single octave down (I don't need the two octave down mode with a bass), so I built my own. it was a large circuit that just barely fit into a 1590B. it sounds really good!

OC-1-01-00.jpg



OC-1-02.jpg

I only just saw this...
Do you have sound clips of the octave pedal you built?
is it a straight oc-2 clone sans 2nd octave?
Thanks
 
I only just saw this...
Do you have sound clips of the octave pedal you built?
is it a straight oc-2 clone sans 2nd octave?
Thanks

yep, it's an exact OC-2 only without the 2 octaves down mode.

I posted a clip of it before but here it is again:

 
Last edited by a moderator:
BTW, I just drew up and built a GK Diesel Dawg on vero board. it sounds really good, although it's a bit noisey (as in hiss), and that's even after I did a few mods to it to reduce the noise.

the nice thing is that it'll fit in a 1590BB which is ALOT smaller than the original. here's a pic of the board while I was testing it:

DawgBoard-01.jpg
 
John- For the TS808 bass mod, did you just increase the input and output caps? I'm thinking of modding my TS9 for bass and also swapping in a Ge diode and LED for the clipping.

I also changed the clipping frequency cap and resistor and raised the value of the drive pot to 1meg.