1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Quick at gig question: V4B

Discussion in 'Amps and Cabs [BG]' started by denton57, Oct 24, 2009.


  1. denton57

    denton57 Supporting Member

    Nov 1, 2005
    Arkansas
    Can I use the ext amp out to send a signal to the board? Pretty sure I can, just want to make sure!
     
  2. jastacey

    jastacey Supporting Member

    Feb 8, 2009
    Houston,Tx
    Yes you can ...just make sure you have a good 12dx7 , a common mod, is to use a 12ax7, in place of the 12dw7, when one couldn't find that tube
     
  3. billfitzmaurice

    billfitzmaurice Commercial User

    Sep 15, 2004
    New Hampshire
    Owner, Bill Fitzmaurice Loudspeaker Design
    Yes, but chances are good that you'll get ground loop noise unless you either transformer isolate or disconnect the cable shield at one end. And the output is at line level, so you have to be sure it doesn't go into a low level input on the board
     
  4. JimmyM

    JimmyM Supporting Member

    Apr 11, 2005
    Apopka, FL
    Endorsing: Ampeg Amps, EMG Pickups
    Two words: mic it!
     
  5. denton57

    denton57 Supporting Member

    Nov 1, 2005
    Arkansas
    Well it was a last second thing and it was going to a recorder. I didn't want to use one of our crappy mics. Have no idea how itturned out yet
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.