That's the sunburst with SF's and flats, right next to another fretless foundation without SF's (that I got a couple weeks ago...bad GAS, I know).
I got home late from practice Monday night and forgot that this was delivered after a heavy shower. I got up in terror when I realized that the bass had been sitting out all night!
I only had time to open the box and inspect the bass quickly before going to work. When I got home and plugged her up, I noticed there wasn't any sound coming from the bridge pup. I opened up the back and this is what I saw:



So, comparing this to what I've seen posted and in the schematics, it looks like the PO switched out the pots to B500K's, got rid of the other caps on the pots, replaced the jack ( possibly), and managed to snap a ground wire from the jack to the bridge pot (maybe while tightening the jack?), all the while getting the soldering rosin all over the factory shielding. The good news? When I jiggle the cable in the jack, I do get sound from the bridge until I shift and then the bridge goes away again.
I want to clean up this mess, should I stick with the B500's or just go back to factory? I've never heard a fretless foundation with SF's before, and I only started getting Peaveys because of TB. What do you guys think?
I was contemplating putting a preamp in one of these (emg btc?), but i do like the passive tone, so maybe I'll just go with an outboard pedal instead.