I recently received my four knob Xerograph filter and aldo have the Oxide fuzz.
When I received the Xero I discovered that the filter is very powerful and perhaps as a consequence, very sensitive to how you adjust it, and as a result, also very versatile.
The Oxide is also quite versatile with it's morph dial ranging from brassmaster like to gated synth, along with an EQ and clean blend knobs.
So, I thought that since there are now a number of Iron Ether users on TB, I'd open a thread on useful settings on the Xerograph and Oxide... and since the Oxide was made to play well with the Xero, we might as well include Oxide into Xero topologies too.
As a general starting place, I found good standard envelope filter sounds in the following settings:
4-pole
Up
Fast
Resonance–about 12:00
Frequency–1:00
Sensitivity–12:30
Volume–12:00
I just got these two beasts, so I'm still in experiment mode... but, I wanted to get the thread going.
So, lets share settings... and clips if you've got'em.
When I received the Xero I discovered that the filter is very powerful and perhaps as a consequence, very sensitive to how you adjust it, and as a result, also very versatile.
The Oxide is also quite versatile with it's morph dial ranging from brassmaster like to gated synth, along with an EQ and clean blend knobs.
So, I thought that since there are now a number of Iron Ether users on TB, I'd open a thread on useful settings on the Xerograph and Oxide... and since the Oxide was made to play well with the Xero, we might as well include Oxide into Xero topologies too.
As a general starting place, I found good standard envelope filter sounds in the following settings:
4-pole
Up
Fast
Resonance–about 12:00
Frequency–1:00
Sensitivity–12:30
Volume–12:00
I just got these two beasts, so I'm still in experiment mode... but, I wanted to get the thread going.
So, lets share settings... and clips if you've got'em.

