Looking for a little advice about the DI on the MG800.
As others have mentioned, it sounds absolutely fantastic, but I'm having a bit of a challenge with the output level going into my band's recording interface. I'm fairly sure the pre-amp in the interface is kind of weak, but even with the volume on either channel of the MG800 abs on the interface extremely low, I am consistently peaking out the input.
In order to avoid peaking the interface I have to turn down the amp volume to the point where I'm not getting enough headroom through the master volume to keep up with the rest of the band.
I'm not sure if there are any tricks to controlling the DI volume that I'm not aware of, or what, but any ideas would be most helpful!