• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Lego instead of velcro

1sbzb5.jpg
 
I think one heavy footed stomp when you're switching effects and it gets knocked loose. Depending on your rig, that could either blow the song or the whole set while you set back up. Get colored Velcro or led strips to make it cool.

The Lego bass is pretty cool.

Plus, there's the pain factor. Stepping on a Lego barefoot in the dark is only slightly less painful than passing stones. You'll undoubtedly have higher chances odd doing this with a Lego project in the works.
 
Extra points if you build the entire pedal board out of Legos. I would suggest gluing them together. I don't see why it wouldn't be strong enough. The only joint I have a difficult time envisioning is the one between pedal and Lego. I think your best bet is to get one with a smooth back so you could double sided tape it on. For that I would guess using super glue and masking tape would be worth a try. Though if I was going this route, I would use some strong glue directly to the pedal and assume I could chip it off later.
 
  • Like
Reactions: rllefebv
its not a bad idea really. there are lego tiles without pegs on top. just smooth flat with the receptacles on bottom. that could be glued or 3m vhb taped to the bottom of the pedal. then you get whole sheets of flat lego with just pegs on top (used as ‘the ground’ for large lego installations) and glue that to a piece of wood for the base. not cheap or practical, but it would be cool and basically functional. it would also open the door for pedal makers to incorporate lego receptacles on the bottom plates of their pedals. aluminum legos. mmmm
 
  • Like
Reactions: Ikkir