Recent content by DickyC

Sounds good to me. Sometimes digital electronics can sound.....well......digital! Adding a valve channel will add some warmth to the sound. Infact im getting myself a valve pre for my setup (When funds allow). Let me know how it goes, and if you fancy selling the tube channel and shipping...

It will work, no problem. The preamp, eq etc is not designed for bass so your sound probably wont be as bassy as a bass amp. As for the power amp side it wont matter and the speakers wont be designed for bass so as the eq really. Most guitar amps speakers will be fine at low level if you...

Glad to hear it. Just to finish off, they are light bulbs, and they act as fuses. When you drive a gazillion watts into your cab then they blow and cost peanuts to replace rather than your tweeter blowing costing (possiably) Hundreds. By the way, just a note on testing things like this, start...

Thanks for your replys. I really just posted for fun but it is great to see what you all like. Im sorry that there was no 2x12" option. I would say (And will probably be put in my place) that the 2x12" combination is quite rare in the UK, i Have not come accoss it much. I would say over here...

Sorry, Im from the UK, The joke is well and truly lost on me!!!!

Are you connecting to it via a speakon connector? Speakon are generally 4 pole and it is likely that it is connected 1+ & 1- Bass driver 2+ & 2- Tweeter. Usually there is a rear switch that makes the cab Bi-Amp or not. You could try bridging between the 4 poles but i wouldnt put money on the...

Is both an option????? I have a little Zoom B2 jobby and it does the job. I really only use a little chorus and reverb sometimes i use some overdrive but VERY rarely. Basically get a cheap multi-FX, spend the rest down the pub. When you know what FX you use then go and buy the single stop...

I was looking for just a valve sound/feel. No OD or distortion just valve warmth. You can get LV valves & I have tried google most are mains and require custom transformers which all gets a little too much of a bind. I was looking along theses lines Link Removed Just thought it...

Thanks for this, Im now off to sit behind a drum kit again! :D Seriously, Thanks all i will start to look into some of these ideas and maybe, just maybe get me a teacher!!!! Rich.

Duracell Procell for me all the way. By far the best battrey in the UK. I just wouldnt bother with the cheapys!!!!

Whats the problem, just vote twice for 1x12!!!!! :D

Hello all, Right, plain and simply i like to fiddle! I am after an easy schematic for a Valve pre-amp that i can put into a little FX type box for my bass. I would prefer that it is low voltage as mains can hurt! Can anyone help???? I know its a daft one but i really like to...

Does that not fall into the 4x10" Category? :D

Out of the plastic cases i would plonk for the SKB. If you do decided to embark on that world stadium tour then let me know and i will see about that custom case!!! :D

If you were to run this with your other cab then i guess it would be 8 Ohms as most amps go down to 4 ohms and the outputs on the rear would be parallel.