Recent content by Rymsk19

I just had a friend set my intonation on my Thunderbird and the action is kind of high, If I lower the bridge (3 point bridge) will it throw out the intonation? Thanks for your help!

Yeah, this model actually came around '91. Atleast thats what Carvin told me.

It is a Carvin Pro Bass 300 Head. Wow! That much, I figured it would be like 95 lol.

Alright, If I have an amp that is 300 watts, minimum load 2ohms. and if I am running it into an 8ohm cab, about how many watts is this thing pushing, and what would it be if I ran it into another 8ohm cab? The amp has two outputs, I would be running one into each cab. Thanks for your help. Sorry...

I would be running parallel. I've always been warned against running a solid state at full wattage. I won't be playing any place huge, just some local bars in a blues/fusion type gig. I am just not sure if the 8ohm 1x15 is enough. I tend to over worry lol.

and if I ran an 8ohm 4x10 with the 8ohm 1x15, Where would the stats be?

Hey guys, I have a Carvin PB300. 300 Watts, 2 ohm minimum. Currently running into an 8ohm 1x15 cab. If I also add a 40hm 4x10, How many ohms would that come to? And about how much wattage would be running then? Thanks in advance!!

I have a 400 watt 1x15 Bass cab, On the back panel it has two jacks, one says Input and the other says "ext. System" Can I use the ext. system jack to run a second line from the output of my head to the Cab?

The only thing I am worried about there is, The screw if smaller wouldnt stay secure in the hole from the previous neck screw.

I have an Epiphone Thunderbird and I was given a pair of Schaller straplocks, the only problem is the screw that goes into the neck of the Bass is too big for the straplocks, Before I go out and buy different straplocks I was wondering if anyone has any suggestions that may fit the Bass.

Alright guys. I have decided on a rig for right now and I want to make sure its all good with power and such. I have a Carvin Pro Bass 300 head, Minimum 2 ohm impedance. and a Seismic 3x10 cab that is 4 ohm impedance 300 watts rms and 600 watts peak. Running my head parallel into the 3x10 I am...

Hey, I just purchased an Ampeg B2RE Head. 450 watts at 4ohms and 250 watts at 8ohms. I want to buy a 4x10 cab that is 8ohm impedance. the cab is rated at 400 watts rms and 800 watts peak. I also would be hooking up my 1x15 that is an 8ohm and can handle 300 watts. Is it safe to use this head...

Hey all, Currently I am running a 1x15 with a Pro Bass 300 Head from Carvin, I am looking to add another cab, I am thinking a 2x10. Would you guys say its a good combination. I really dont want to lug a 4x10 around lol.

Alright, I got this figured out finally thanks guys!

So, if I run one output of the amp to one cab and the other output of my amp to the other cab (Parallel) it will be 4 ohms in all?