The closest I've seen to any confirmation is on the [Invalid or Expired Link Removed], but even still, the answer is a little shaky.Are the controls on the Aerodyne without the plate like mine the same spacing as a reg jazz with a control plate? Just wondering if a preamp setup with a plate could be used by removing the knobs off the plate and dropping it in where the holes are on the non-plate. Like an Audere ect.
Will it work in my Fender Jazz Bass?
It works in all common jazz basses - US, Mexican, Squier, Highway One, Geddy, Japan models etc...
It is notable that the Aerodyne is problematic with a very thin body and slightly curved top - a few players have managed to units to fit into these basses but these mods are at your own risk.
It will not fit some of the Jaguar basses with the small curved plate.
It works in all common jazz basses - US, Mexican, Squier, Highway One, Geddy, Japan models etc...
It is notable that the Aerodyne is problematic with a very thin body and slightly curved top - a few players have managed to units to fit into these basses but these mods are at your own risk.
It will not fit some of the Jaguar basses with the small curved plate.
I suppose the first step to find out would be to remove an Aerodyne's knobs and lay a Jazz's control plate over the pots to see if they line up or not.
There's a company called "Guitar Fuel/Tone Monster" that makes a series of preamps without a module. Rather, their SBK series has circuitry attached to the individual pots. You still need a battery in there somewhere, but it might be worth hitting them up with a few questions. Maybe they have some kind of solution?
over them!
Kanda-Shokai didn't shy away from taking the extra step of giving their headstocks a burst finish for some of their special edition 'Dynes, you lazy sacks!