• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

My New Studio Build (perhaps overly detailed)

The roof work was fast.

How does the ridge cap that they installed work in terms of rain? If you get rain gusting from the side, can it get into the air gap and into the rafters?
I worked as the grunt for a roofing company when I was in college, and this is very common for ridge vents here in Washington. Occasionally you'd see guys run the OSB all the way to ridge and then pop in a series of holes on both sides of the ridge, but this is the far more common approach.

I suppose if you had winds blowing strong enough to rip the shingles off you could have a path for water intrusion, but given that this is the ridge cap which gets twice as many nails and on both sides, I'm not concerned. The building is pretty well protected on both sides from wind as is, so I'm even less concerned.
 
  • Like
Reactions: beans-on-toast
I was looking at a rural property last weekend that had an outbuilding that would be well suited for a studio conversion. One concern that came to mind is security. I'd want a security (alarm, video, lighting) system for sure but I'd worry about leaving mics and other portable pieces of gear unattended.

In your case, having the studio so close to your home is a big plus.
 
Some photos from yesterday's roof installation.

Stuff
DSC_3147.jpg


This shot takes me back to the work I did while I was going to college
DSC_3141.jpg


Ridge venting and radiant barrier
DSC_3150.jpg


Bird blocking at the soffit vents
DSC_3149.jpg
 
It has been my experience that if you're going to hire a guy/ crew to mud and tape and finish your drywall.....you may as well pay those same guys the extra ten minutes it will take them to hang it as well. Two guys could do that WHOLE thing in an hour and a half.


I love this thread man!
I'm hanging drywall on Whisper Clips and hat channel with a minimum stand-off distances from the walls, specific screw schedules so no drywall is anchored to a stud, Green Glue in between layers and acoustic sealant on all perimeters... I'm not trusting drywall guys to get that right and blow my entire isolation perimeter. Hang one sheet a 1/4" off, or sink one screw into a stud and the whole thing is shot. No-no... I'll be doing that part myself.