• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Worship Bass Pedalboards

Isn't it unity gain at around 10 o'clock? Because it goes -6dB to 12+dB

All the filters boost and cut also, so those are additional factors. There are a ton of capabilities in the OSC that I haven't fully explored yet. (can't wait! - rehearsal tomorrow :) )
 
Was there noise or just more gain?
Bingo! I'm more interested in any quality differences detected with the bass channel signal (noise floor, etc vs strength) a/b'd...checked at three areas: headphones at the board, FOH clarity, and IEM monitor channel.

Having more gain sent to the board "could" be a good scenario, but...

Unfortunately, I don't have a JDI box, and our church DI boxes are THE cheapest/worst available! To date, I've slways used my Jule Monique preamp between my pedalboard and FOH [which has a top quality (Jensen-type) transformer DI built-in...]

A/b'ing with my Monique (or Noble) would bring other variances into the equation...

[EDIT: add]
Bottom line...I'm hoping the DI quality IS comparable to using a JDI box! Only schlepping a pedalboard is the goal... :thumbsup:
 
Last edited:
Our church has been using an Aguilar Tone Hammer Pre/DI but I've been bringing my Markbass Super Booster and like it for it's clean tone and ability to give it the old school vibe using the VLE. I run passive basses therefore use active DIs. I've heard good things about the Radial Stagebug SB-1 for passive basses. Have been considering the OCSD.

Active DIs for passive basses, passive DIs for active basses. In the end it all boils down to what works, which a lot of times, is found through trial and error.
 
  • Like
Reactions: ExaltBass and kevk
So after years of not playing at church (or any other live setting) this weekend I jumped back into it. Previous church was small (~60) and current has capacity for about 400. One Saturday night service,2x Sunday morning. Had a great leader and drummer so was super easy to roll with.
My simple setup below: MIM Geddy Lee to Korg Pitchblack Custom tuner to Vt Bass v1 to church's Radial JDI.
Next up is a compressor methinks.

67D445D7-2CAD-4267-B3CA-978ABB2949A1.jpeg
 
Last edited:
View attachment 2937905 Back to the Nano...best sound I've had in a long time.

With all of the positive comments on the OnmiCabSim I am going to have to keep it in mind. We are moving this summer and will be looking for a church. IF I get to play, that sounds like a great solution for no amps/cabs on stage. Right now I have a "decent" rig on the stage - Genz Benz Streamliner 900 into an Accugroove El Whappo! IMHO, the BEST rig I have heard!

TalkBass GAS again! :D

Dan
 
  • Like
Reactions: Rayjay and SteveC
So after years of not playing at church (or any other live setting) this weekend I jumped back into it. Previous church was small (~60) and current has capacity for about 400. One Saturday night service,2x Sunday morning. Had a great leader and drummer so was super easy to roll with.
My simple setup below: MIM Geddy Lee to Korg Pitchblack Custom tuner to Vt Bass v1 to church's Radial JDI.
Next up is a compressor methinks.

Nice Geddy! Love my jazz, but my VMP5 usually gets the nod for church.

For research into compressors, check here -
Compressor and Audio Gear FAQ
Compressor Reviews
My top picks

Love my Markbass Compressore, just wish it wasn't 12V ...